The master knob could control the master level. In addition, the phones knob could control the headphone volume and the pfl mix knob could control the Cue-Mix level. Everything else seem to be mapped correctly.
The bend buttons seem to do not do anything. Only knob D works but to control Params 1 on turntable 2. The FX params 1 and 2 for Turntable 1 work fine with knobs A and B, but knobs C and D do not work correctly. Is there any way to customize it to what each button does? What does button B and C do? Good for keylock I think. Button A works to enable the FX on Turntable 1 and Button D works on Turntable 2.
The FX Control buttons on the BCD2000 do not work well with Virtual DJ, at least on my setup. it must be typed in the mapping file and it must be the 1st command in the output section.I just realized that the button mappings are not set correctly on the BCD2000 since I do not use FX that often. This command can not be mapped using MIDI learn. The one thing missing is the address or parameter in this case I just put 100 but that must be somewhere in the controller's documentation. That command is from the software to the controller telling it to send the status of all controls and LEDs. Then it comes the output section which starts like this and in your case it will look like this That means that when toggle button on address 43 channel 3 on the controller the software is going to PayPause. The mapping file contains input commands and it starts like thisįollowing that is a series of commands from your controller to the software Code: Select all My question is simple how do I request the Cross software to send the "Data request " to start this procedure? This affects all knobs and faders apart from both wheels and buttons" If the "Data request " command(demand for data) is sent from a suitable software application to the BCD 3000 as "control change" command (100) on a MIDI channel 1 the B CONTROL transmits its current control settings to the MIDI or DJ application. I have tried to do the mapping but have not been successful then I read the following in the Behringer manual.
0 kommentar(er)
